Wavelength Calibration Lamps for Spectrometers Atomic lines, not a continuous spectrum. Five lamps covering 253 to 1984 nm, fibre coupled through SMA 905. Mercury argon for UV and visible, argon and xenon for the NIR.
Arc Lamp Igniters and Xenon Lamp Power Supplies Power supplies that carry the igniter inside the case. Plus 15 kV trigger pulses, 4 strikes per second, over 80,000 strikes. Cermax xenon and mercury versions, 100 to 300 W constant power.
Xenon and Deuterium Lamps for Photometric Instruments A photometer is a lamp with an optical bench in front of it, and the lamp sets both the wavelength range and the noise floor. Deuterium covers the deep UV with a continuum that reaches 115 nm on a fluoride window; xenon covers 185 nm to 2,000 nm with a small, bright arc. The parts below run from a 75 W xenon arc with a 1.3 mm source size up to a 300 W forced air lamp, and from a 2,000 hour long life deuterium body down to a 1,000 hour high intensity type. Window material is the number that decides the short wavelength cut off: UV glass stops at 185 nm, synthetic silica reaches 160 nm, and a magnesium fluoride window reaches 115 nm. Each line gives the drive figures, the guaranteed life and the trigger voltage together, because a lamp that matches the optics and not the starter will not light.
UV and Visible LED Sources for Photometric Detection A photometer does not care how bright an LED looks, it cares how much radiant power arrives at one wavelength, and that figure is quoted in milliwatts rather than lumens. The parts below run from 255 nm to 627 nm and cover the bands a fixed wavelength photometer uses, with spectral width from 10 nm to 30 nm. Each entry gives the peak or dominant wavelength, the radiant power or flux at its test current, the forward voltage and the package. The deep UV parts deliver microwatts to a few tens of milliwatts, so the optical path and the detector gain are decided before the LED is chosen.
Seven Segment LED Displays for Instrument Readouts A seven segment display is chosen on digit height, common pin and colour, and then on whether the driver can supply the current.\nThe 14.22 mm parts here give 3,600 to 8,000 ucd at 10 mA in high efficiency red, and 14,000 to 34,000 ucd in super bright red.\nForward voltage is 1.9 V typical at 10 mA, with a 30 mA DC and 160 mA pulsed limit on the standard red part.\nCommon anode and common cathode versions share the same 10 pin package and the same 2.54 mm pin row.
High Power LED Emitters for Illumination and Infrared A high power emitter is a thermal part before it is an optical part, because the flux figure is quoted at a junction temperature the board has to hold. White parts on this page run to 2000 mA and infrared parts to 2 A pulsed, and both need a metal core board and a defined solder pad. Flux bins and forward voltage are given per order code, since the same family ships in several bins. Every row lists drive current, forward voltage and viewing angle.
GaN HEMT RF Power Transistors for Broadband Amplifiers GaN on SiC RF power transistors for broadband amplifiers from 6 W to 120 W. 28 V, 40 V and 50 V rails, unmatched parts that are matched on the board. Flange, pill, DFN and die options for radar, electronic warfare and radio links. Cross reference and long term supply are checked against the maker data sheet.
Thermoelectric Coolers and Peltier Modules for Precision Cooling A Peltier module moves heat when current flows, and reversing the current moves it the other way. Sub watt modules stabilise laser diodes, photodiodes and crystal oscillators where the load is small and the set point is tight. Larger single stage modules pump 7 W to 53 W for instrument chambers and reagent blocks. Every figure is quoted at a stated hot side temperature, because Qc and delta T both fall as that temperature rises.
Thermal Fuses and Temperature Cutoffs for Battery and Heater Safety Axial one shot cutoffs cover 72 C to 240 C, with 10 A, 15 A and 25 A ratings at 250 VAC. The opening temperature is not the number printed in the code, so the table lists the tested value for each order code. Holding temperature and maximum overshoot are listed as well, because those set the margin in normal operation. Surface mount protectors add a heater terminal for an active cutoff inside a lithium pack.
Small Signal Bipolar Transistors for Switching and Amplification The complementary pairs cover 40 V at 200 mA and 45 V at 100 mA in TO-92 and SOT-23. The 800 mA part carries four times the current of the standard switching transistor at 40 V. Gain groups run from 100 to 300 and from 200 to 450, and the group letter is part of the code. Transition frequency, power rating and package are listed per code, because they set the drive.
Zener Diodes for Voltage Reference and Clamping Axial 1 W parts cover 3.3 V to 56 V in DO-41, with test currents from 76 mA down to 4.5 mA. Axial 0.5 W parts in DO-35 cover the same voltage range at 20 mA test current. Surface mount parts in SOT-23 cover 5.6 V to 39 V at 5 mA and 300 mW. Zener impedance and reverse leakage are listed per code, because they decide the regulation and the loading.
Thyristors and SCRs for AC Power Control Sensitive gate SCRs start at 200 uA of gate current, which a microcontroller can drive without a buffer stage. Phase control parts run 4 A to 12 A RMS at 500 V to 600 V, with surge ratings from 20 A to 145 A. The 25 A family blocks 400 V, 600 V or 800 V and takes 250 A of half cycle surge current. Every row lists the trigger current, the holding current and the package, because those decide the gate drive.
TLP621 TLP621: Phototransistor optocoupler, DIP-4. Original parts with traceability, small quantities and fast quotes from SUPERB.
BZX84C12 BZX84C12: 12 V zener voltage regulator diode, SOT-23. Original parts with traceability, small quantities and fast quotes from SUPERB.
PU6BBH PU6BBH: 100 V, 6 A surface mount rectifier, SMB. Original parts with traceability, small quantities and fast quotes from SUPERB.
VS-50WQ10FN-M3 VS-50WQ10FN-M3: Schottky rectifier, 30 V, 5.5 A, D-PAK. Original parts with traceability, small quantities and fast quotes from SUPERB.
SMCJ75CA SMCJ75CA: 75 V bidirectional TVS diode, 12.4 A peak pulse, SMC. Original parts with traceability, small quantities and fast quotes from SUPERB.
AP18N20GH-HF AP18N20GH-HF: 200 V, 19 A N-channel power MOSFET, TO-252. Original parts with traceability, small quantities and fast quotes from SUPERB.
YINC2410-1500T YINC2410-1500T: 5 A / 250 V time-lag SMD fuse, 2410. Original parts with traceability, small quantities and fast quotes from SUPERB.
Inline Fuses and Resettable PTC Fuses for Board Protection Cartridge fuses in a 5 x 20 mm body, 5 A at 250 V AC with a 1.5 kA breaking capacity. Axial PICO fuses at 5 A, 125 V AC and DC, in a 3.18 x 7.10 mm epoxy coated body. Resettable PTCs from 0.5 A to 3.0 A hold, 6 V to 72 V, in 1206, 1812, 2920 and radial packages. Each row lists hold current, trip current and resistance, because those three decide the replacement.
Laser Diodes and VCSEL Emitters for Optical Modules Pulsed 905 nm laser diodes from 70 W to 120 W peak, driven at 30 A to 40 A in a TO-56 can or as a bare die. 850 nm VCSELs at 0.5 mW to 2 mW, and 850 nm datacom VCSELs rated to 10.3125 Gbps, all in TO-46. One 447 nm blue emitter at 3.5 W continuous in a TO-90 can, with 2.2 A of forward current. Every row lists the wavelength band, the drive current and the package, because the package sets the heat path.
Power Relays and Signal Relays for Load Switching PCB power relays from 10 A to 12 A at 250 V AC, in sugar cube and low profile cases. Signal relays from 0.3 A to 2 A with 100 mW to 150 mW coils, plus a reed relay with a 0.5 ms operate time. Coil resistance, must operate voltage, contact resistance and mechanical life are listed per part number. Sealed and flux tight versions are quoted with the washing process the board uses.
Varistors and Gas Discharge Tubes for Surge Protection Metal oxide varistors from S05 to S20 discs, 11 V to 1100 V RMS, with energy from 0.3 J to 151 J. Two electrode gas discharge tubes from 75 V to 1000 V, up to 20 kA on an 8/20 us wave. Clamping voltage, peak current and capacitance are listed per part number. The two device types are quoted together with the coordination resistor between them.
IGBTs and SiC Power Devices for Motor Drives and Inverters IGBT and SiC MOSFET discretes covering 600 V to 1200 V in TO-247, TO-247-4 and TO-3P packages. On-state values are taken from the maker data sheet at the quoted current and temperature. Co-packed IGBTs, SiC MOSFETs and SiC Schottky diodes are quoted together for one phase leg. Parts under an end of life notice are flagged with the nearest equivalent that keeps the footprint.
TVS and ESD Protection Diodes for Telecom and Industrial Interfaces Steering diode arrays from 0.3 pF for high speed pairs, surge suppressors from 130 W to 1500 W Asymmetrical 12 V and 7 V RS-485 parts and 24 V bidirectional CAN protectors IEC 61000-4-2 level 4 arrays with IEC 61000-4-4 and IEC 61000-4-5 surge ratings Order code, reel suffix and batch data confirmed against the exact part number
LED Indicators and Optocouplers for Status and Isolation 0603 and 0805 chip LEDs plus 5 mm through hole indicators for board status Phototransistor optocouplers from 50 percent CTR for signalling and feedback 10 MBd logic gate couplers for digital isolation and line receiving Phototriac couplers for AC switching with zero cross options
N-Channel and P-Channel Power MOSFETs for Motor Drive and Power Conversion N channel parts from 30 V to 500 V, 4 mOhm to 0.85 Ohm on resistance P channel complements from 55 V to 100 V for high side and load switching Logic level, standard and avalanche rated versions for motor drive All models on this page are grouped into one part for easy sourcing
BAT43XV2 The BAT43XV2 is onsemi's small-signal Schottky barrier diode, delivering 30V reverse voltage and 200mA forward current in an ultra-compact SOD-523 flat-lead package only 0.60mm high. Its Schottky metal-semiconductor junction provides a low forward voltage drop (0.33V typical at 10mA) and 5ns reverse recovery time, enabling high-speed switching and efficient low-voltage operation that silicon PN-junction diodes cannot match. With matte tin lead finish, green mold compound, and MSL-1 moisture rating, it is the ideal diode for high-frequency signal detection, RF/microwave detection, reverse polarity protection, and low-voltage rectification in space-constrained surface-mount designs.
HXC50073 Hisiwell HXC50073 is a discrete semiconductors component designed for DC-DC Converters & Power Supplies and related applications. In stock at Superb Automation — request a quote for competitive pricing and fast delivery.
HXC50070 Hisiwell HXC50070 is a discrete semiconductors component designed for DC-DC Converters & Power Supplies and related applications. In stock at Superb Automation — request a quote for competitive pricing and fast delivery.
HXC50184 Hisiwell HXC50184 is a discrete semiconductors component designed for DC-DC Converters & Power Supplies and related applications. In stock at Superb Automation — request a quote for competitive pricing and fast delivery.
HXC50131 Hisiwell HXC50131 is a discrete semiconductors component designed for DC-DC Converters & Power Supplies and related applications. In stock at Superb Automation — request a quote for competitive pricing and fast delivery.
HXC50133 Hisiwell HXC50133 is a discrete semiconductors component designed for DC-DC Converters & Power Supplies and related applications. In stock at Superb Automation — request a quote for competitive pricing and fast delivery.
HXC50135 Hisiwell HXC50135 is a discrete semiconductors component designed for DC-DC Converters & Power Supplies and related applications. In stock at Superb Automation — request a quote for competitive pricing and fast delivery.
HXC50136 Hisiwell HXC50136 is a discrete semiconductors component designed for DC-DC Converters & Power Supplies and related applications. In stock at Superb Automation — request a quote for competitive pricing and fast delivery.
HXC50187 Hisiwell HXC50187 is a discrete semiconductors component designed for DC-DC Converters & Power Supplies and related applications. In stock at Superb Automation — request a quote for competitive pricing and fast delivery.
HXC50020 Hisiwell HXC50020 is a discrete semiconductors component designed for DC-DC Converters & Power Supplies and related applications. In stock at Superb Automation — request a quote for competitive pricing and fast delivery.
HXC50019 Hisiwell HXC50019 is a discrete semiconductors component designed for DC-DC Converters & Power Supplies and related applications. In stock at Superb Automation — request a quote for competitive pricing and fast delivery.
HXC50132 Hisiwell HXC50132 is a discrete semiconductors component designed for DC-DC Converters & Power Supplies and related applications. In stock at Superb Automation — request a quote for competitive pricing and fast delivery.
HXC50062 Hisiwell HXC50062 is a discrete semiconductors component designed for DC-DC Converters & Power Supplies and related applications. In stock at Superb Automation — request a quote for competitive pricing and fast delivery.