TMS5700232BPZQQ1
Product Specifications
TMS5700232BPZQQ1
Texas Instruments — Power Management & Signal Chain
Product Overview
The TMS5700232BPZQQ1 from Texas Instruments is a power management / signal chain IC delivering high efficiency, precision regulation, and robust protection. Texas Instruments (TI) is a global leader in analog ICs, power management solutions, and embedded processors.
Superb Automation partners with leading brands including Qorvo, TI, ADI, XILINX, NVIDIA, Intel, ST, MACOM, Renesas, and Coilcraft to provide complete BOM and supply-chain solutions.
Key Features
- High-efficiency power conversion with low quiescent current
- Wide input voltage range with precision output regulation
- Integrated over-current, over-temperature, and short-circuit protection
- Small footprint packaging for space-constrained designs
- AEC-Q100 qualified options available for automotive applications
- Flexible sequencing and soft-start control
Key Specifications
| Input Voltage | V |
| Output Voltage | V |
| Output Current | A |
| Switching Frequency | kHz |
| Efficiency | % |
| Quiescent Current | µA |
| Topology | — |
| Package | — |
| Operating Temp | °C |
| Protection | — |
Applications
Request Quote — In Stock, 100% New & Original, Full Warranty
TMS5700232BPZQQ1: lockstep Cortex-R4F safety microcontroller, 128K bytes of flash, 100 pin body, automotive grade
TMS5700232BPZQQ1 is a dual core lockstep safety microcontroller that runs two Cortex-R4F cores in parallel and compares every cycle, for control loops where a silent arithmetic error is not acceptable in a LQFP body of 100 pins. The LS0232 is the smallest member of the Hercules TMS570 line and it keeps the whole safety architecture: dual CPUs in lockstep, ECC on the flash and the RAM interfaces, built in self test for the CPU and the RAMs, an error signalling module with an external error pin, and voltage and clock monitoring. Memory is 128K bytes of program flash, 32K bytes of RAM, both with ECC, and 16K bytes of flash set aside as emulated EEPROM. The B in the code is the silicon revision and PZ is the 100 pin LQFP body.
Order code and package
| Order code | TMS5700232BPZQQ1 |
| Core | dual ARM Cortex-R4F in lockstep, 1.66 DMIPS per MHz |
| Clock | 80 MHz system clock |
| Package | LQFP, 100 pins, body code PZ, 14 by 14 mm |
| Flash | 128K bytes with ECC |
| RAM | 32K bytes with ECC |
| Emulated EEPROM | 16K bytes of flash with ECC |
| ADC | 12 bit, 16 channels, 64 result buffers |
| CAN | two controllers, 32 and 16 mailboxes, parity protected |
| Supply | 1.2 V core, 3.3 V I/O, 3.3 V ADC |
| Temperature | minus 40 to 125 C, automotive Q1 grade |
| Datasheet | SPNS242A, revised June 2015 |
Electrical parameters that decide the application
| Safety architecture | lockstep CPUs, CPU and RAM self test, ECC on flash and RAM, error signalling module |
| Error pin | external nERROR output toggled on a detected fault |
| Core supply current | 135 mA typical in operating mode at 80 MHz |
| I/O supply current | 45 mA typical with no DC load |
| Program and erase current | 65 mA typical on the 3.3 V rail during a flash operation |
| N2HET | 19 programmable pins, 128 word instruction RAM, hardware angle generator |
| eQEP | one module for motor position |
| Serial | two DCAN, one MibSPI, two SPI, one SCI with LIN 2.1 support |
| Interrupts | 96 channel vectored interrupt module |
| CRC | two channel checker |
| Memory protection | 8 region MPU |
| Package thermal | 100 pin LQFP, thermal pad on the board recommended |
Points to check before this part goes on a BOM
Lockstep is the whole product. The second core runs the same instructions one cycle behind and the comparator checks the results, so a single event upset in the core that changes a branch or an arithmetic result is caught before the output reaches an actuator. That is why the part is chosen for steering and braking, and it is also why the firmware has to be built for it: a lockstep device with an unchecked error pin gives the diagnostic coverage on paper only.
The error signalling module drives an external pin, and the board has to route that pin to something that can act. In the usual arrangement it pulls the enable of a gate driver low or trips a safety relay. If the pin is left unconnected, every internal fault becomes a silent log entry, and the safety case falls apart at the first audit even though the silicon is doing its job.
The 16K bytes of flash used as emulated EEPROM is a separate area with its own ECC. It is the right place for calibration and for fault logs, and it is not a general purpose scratch area: the erase granularity and the endurance are that of flash, so a log written every second will wear it out inside the life of the product. Batch the writes and rotate the block.
The two CAN controllers are parity protected on their mailbox RAM, which matters in a vehicle because a corrupted mailbox can put a wrong torque request on the bus. The message RAM protection is as much part of the safety story as the lockstep core, and the software has to check the parity error flags rather than only the bus error counters.
The 12 bit ADC has sixteen channels and sixty four result buffers, and the buffers are parity protected. A control loop that reads a stale result because the buffer was not refreshed looks like a sensor fault, so the conversion sequence and the trigger source have to be tied to the PWM period and the buffer index checked in software.
The Q1 marking is the automotive grade and the data sheet specifies this device from minus 40 to 125 C. Parts that arrive without the full marking, or with a date code that does not match the reel, are the main counterfeit risk on this line. We buy through traceable channels and we check the marking, the date code and the packaging on receipt.
Where this order code fits
Electric power steering, braking and stability control, battery management in hybrid and electric vehicles, electric pump and fan control, and railway or avionics subsystems that need the same diagnostic coverage without the full size of the larger members of the family. Boards comparing it with a neighbouring part start from our MCU Cross Reference page, and boards replacing a part that has gone end of life start from the Incoming Inspection Plan page.
Questions buyers ask
What does the lockstep pair actually protect against? It catches a fault in the core that changes a computation, a branch or a register value, because the second core runs the same code and the comparator flags any difference. It does not replace the external watchdog or the error pin wiring; those are what turn a detected fault into a safe state.
Can this part be used without the safety software package? The silicon runs without it, but the diagnostic coverage that the grade is bought for depends on the self test and the error handling being enabled and checked. A board that ignores the error pin has the cost of a safety part without the benefit.
How much code fits in 128K bytes? Enough for a single function controller with a CAN stack and a motor loop, not enough for a gateway with several protocol stacks. The larger members of the family carry 256K and 384K bytes in the same 100 pin body, so the choice is made on code size rather than on pins.
SUPERB holds and sources this Texas Instruments line for production and repair demand, quoted against the exact ordering string with date codes, packing and country of origin stated on the offer. When a line is moving, the Supplier Quality Audit page sets out the checks that keep a substitute from failing on the bench.