Contact Us
  • Home
  • PCBA
  • Robot Docking and Charging Board PCBA for Autonomous Fleets

Robot Docking and Charging Board PCBA for Autonomous Fleets

Docking and charging board PCBA for autonomous robot fleets. Contact management, charge current control, temperature sensing, CAN reporting to the fleet.
quote now

Product Specifications

Product Overview

The docking board manages the moment a robot connects to a charging station: it detects the contact, checks polarity, ramps the charge current, watches cell temperature, and reports state to the fleet controller.

The failure modes are mechanical and electrical at once. Contacts bounce as the robot aligns, an arc can pit the contacts, and a mis-aligned dock can connect the wrong pair. The board has to survive those events without welding the contacts or damaging the pack.

We build the dock board on 4 to 6 layers with 2 to 3 oz copper on the charge path, arc suppression at the contacts, and isolated sensing for pack voltage and temperature.

Key Specifications

Layer count4 to 6 layers, 1.6 mm
Charge pathUp to 30 A, 48 V
Contact detectionVoltage sense with debounce
ProtectionReverse polarity, over-current, arc suppression
SensingPack voltage ± 0.5%, two temperature channels
ControlCharge current ramp, 0 to 30 A
CommunicationCAN 2.0B to fleet controller
IndicatorsDock status LED and beeper
Operating temperature-20 to +60 °C
CoatingConformal coat, contacts masked
MechanicalSpring-loaded contacts, 20 mm alignment tolerance
Test coverage100% ICT, load test, contact bounce simulation

PCBA Assembly Challenges

  • Contact bounce during docking produces repeated make-break events; the board must debounce in hardware so the controller sees one connection, not ten.
  • An arc at the contact pits the plating and raises contact resistance over time; suppression has to act before the contact separates under load.
  • Temperature sensors sit in the pack, not on the dock board, so the measurement needs a filtered, protected input that survives a shorted sensor cable.
  • The charge path and the sensing share the same connector, so Kelvin connections are needed to keep the voltage reading accurate at 30 A.

Test Strategy

Every dock board is tested under load and with simulated mis-alignment:

  • In-circuit test on all nets, including the Kelvin sense path.
  • Load test at 30 A for 30 minutes, with contact temperature recorded.
  • Contact bounce simulation: 100 connect/disconnect cycles with the event log checked.
  • Reverse polarity and shorted sensor fault injection.
  • CAN reporting test with a reference fleet controller.

PCB Manufacturing Difficulty

3 oz copper on the charge path needs multiple vias per layer transition; a single via becomes the hot spot at 30 A.

Arc suppression components sit close to the contacts, which forces a layout compromise between creepage and loop area.

Coating must stop at the contacts; a coated contact surface raises resistance and the dock fails in the field.

Applications

  • AMR fleets with automatic charging docks
  • Humanoid robots that return to a station
  • Cleaning robots with self-docking
  • Warehouse robots with opportunity charging
  • Service robots in retail and hospitality
  • Test fixtures that emulate dock behaviour

Why Superb Automation

  1. Engineering review before tooling: stack-up, copper weight, creepage and assembly sequence are checked against the drawing before the first panel is released.
  2. PCB fabrication and PCBA assembly held to one schedule, so the bare board and the assembly do not slip against each other.
  3. Incoming component inspection with X-ray and XRF on reels, plus traceability records per lot.
  4. Selective conformal coating, potting and staking available in the same build, not subcontracted to a third party.
  5. Functional test fixtures built to your specification, with DC, digital and boundary-scan coverage reported per unit.
  6. Quotation from one BOM and one drawing set, with DFM feedback returned before you commit to a build.